Void INFINITE QX 6 Instrukcja Obsługi Strona 1

Atlas Model Railroad Co, Inc. • 378 Florence Ave. • Hillside • NJ • 07205INSTRUCTION MANUALFOR TECHNICAL ASSISTANCE:[email protected]

Programming A Locomotive’s Decoder Address1. Place the locomotive to be programmed on the program track. Forinformation on creating a programming trac

Display What To DoPress Enter to access the Program Menu.Use the “+” or “-”button to select a register, and press Enter.Press the Enter button to read

is the Lead address. If the display shows "n" the address is part of a Consist,but not the Lead address.While a locomotive is part of a Cons

Display What To DoPress Exit to return to the Menu Selection. Press Enter to viewthe version number. This selection cannot be changed.This menu allows

Display What To DoPress Enter to access the System Menu.Use the “+” or “-” button to select the XpressNET addressmenu.Press Enter and the current Xpr

ADDING MORE POWER TO YOUR LAYOUT• Any trains (including lighted passenger cars) that you run on your layoutrequire power to operate. The more trains y

TABLE OF CONTENTSGetting Started... 3Decoder Preparation...3Setting Up Your Layout

flat wire) and it supports XpressNet technology. Visit the DCC section of ourweb site for more information at www.atlasrr.comMISCELLANEOUS ITEMS YOU W

4. Using an Atlas Controller to select Mainline or Program track.Connect the Commander to an Atlas Controller as shown in Figure 2.• Connect the Contr

* The number of accessible functions depends on the capabilities of thedecoder installed in your locomotive.“+” and “-” - Used to select the address

function 4 - F4. Examples of additional functions are sound, (bells, horn, whis-tle) and / or ditch lighting, or strobe lights. Consult your decoder&a

RECALLING LOCOMOTIVESThe Commander has a “stack” feature which remembers the last eight loco-motives acquired. To recall a locomotive from the stack,

Controlling Turnouts or other AccessoriesAccessory decoders, like your locomotives, require a unique address to allowindependent control. Most accesso

Display What To DoPress the “+” or “-” button to select the desired speed step(14, 28 or 128)*.Once the desired speed step appears, press Enter to acc