RECALLING LOCOMOTIVES
The Commander has a “stack” feature which remembers the last eight loco-
motives acquired. To recall a locomotive from the stack, press either the
Forward or Reverse button (depending on the direction the locomo-
tive is traveling) and then the “+” or “-” button to scroll through the
stack until you reach the desired locomotive. Since the stack remembers the
last eight locomotives you have acquired; any locomotives acquired prior to
the last eight are not accessible via the stack. For example, if the stack con-
tains locomotives 1,2,3,4,5,6,7,8, and you access another locomotive (ie.,
locomotive 9), the stack will forget locomotive 1 and remember locomotives
2,3,4,5,6,7,8,9. The locomotive which is dropped from the stack is the oldest
locomotive in the stack, not necessarily the lowest address.
Acquiring a locomotive that is currently running:
When selecting a locomotive from the stack, you may adjust the speed dial to
approximate the locomotive’s speed, prior to releasing the direction button.
When acquiring a locomotive directly, using the “+” or “-” buttons, select
the locomotive address on the display. Then press and hold the direction but-
ton which corresponds to the locomotives direction, and adjust the Speed dial
to approximate the speed of the locomotive, then release the direction button.
THE MENU
The Commander has a Menu System which is used for the following set-
tings and functions:
• Controlling turnouts • Adjusting system settings • Setting speed steps
• Programming and reading decoder parameters • Consisting
Accessing the Menu
Press both Forward and Reverse buttons at the same time to access the
Menu system. The display changes and now shows the last used menu. You
may scroll through the menu choices using the “+” and “-” buttons.
When you reach the desired menu, press the Enter button to access the set-
tings in that menu or press the Exit button to return to the locomotive dis-
play.
Menu Selections
This menu is used to control turnouts, or other accessories.
NOTE: You must have an accessory decoder attached to one or
more turnouts on your layout for this function. For more about
controlling turnouts, see next page.
This menu is used to select the speed steps of the selected
locomotive decoder.
This menu is used to display or program a decoder and its
parameters.
This menu is used to change the system settings.
This menu is used to setup or separate consists.
11
12
.
(261 strony)
(92 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji